A view from the front, showing the power switch and indicator light installed in the Frac Rack ear with the sine-to-pulse module installed next to it.
	A view from the back showing the power supply on the right, attached to a wall of the enclosure with standoffs and machine screws. On the left is the Sine-to-Pulse module.
	Another inside view. At the extreme right is the power cord connector and the hole where the fuse holder will go (broke first one during installation, argh). The connectors which are used to run power from the supply to the module are 5.25" disk drive type from Jameco.
	The power distribution board. There's room for three more connectors.